鈥?/div>
Supports nibble, byte and EPP mode parallel
port standards
DESCRIPTION
The ST20-JPI parallel port to JTAG interface is
a host interface to allow connection from a PC
parallel port to any JTAG diagnostic controller
based ST20 development board. The interface
plugs into any standard PC 25 way D-type
parallel port. Supported parallel port modes
are:
鈥?/div>
Nibble mode
鈥?/div>
Byte mode
鈥?/div>
EPP mode
depending on which mode the host PC can
support. Connection to the development target
is via a 20 way IDC JTAG connector. Once
connected, the development target can be
accessed using the MS Windows drivers
supplied with the standard ST20 toolset.
September 1996
1/10
42 1685 00
next