鈻?/div>
500 V / 0.57
惟,
160 W (120 Vac input)
Description
The STR-W6735 is a quasi-resonant topology IC designed for
SMPS applications. It shows lower EMI noise characteristics
than conventional PWM solutions, especially at greater than
2 MHz. It also provides a soft-switching operation to turn on the
internal MOSFET at close to zero voltage (V
DS
bottom point)
by use of the resonant characteristic of primary inductance
and a resonant capacitor.
The package is a fully molded TO-220, which contains the
controller chip (MIC) and MOSFET, enabling output power up
to 160 W with a 120 Vac input. The bottom-skip function skips
the first bottom of V
DS
and turns on the MOSFET at the second
bottom point, to minimize an increase of operational frequency
at light output load, improving system-level efficiency over
the entire load range.
There are two standby functions available to reduce the input
power under very light load conditions. The first is an auto-burst
mode operation that is internally triggered by periodic sensing,
and the other is a manual standby mode, which is executed
by clamping the secondary output. In general applications,
the manual standby mode reduces the input power further
compared to the auto-burst mode.
The soft-start function minimizes surge voltage and reduces
power stress to the MOSFET and to the secondary rectifying
Continued on the next page鈥?/div>
Continued on the next page鈥?/div>
Package: 6-pin TO-220
Typical Application
+B
ErrAmp
P
A
S1
GND
Standby
ON/OFF
LowB
S2
D
1
4
V
CC
D
STR-W6735
B
SI
Standby
Out
GND
Cont
6
FB
3
7
5
S/GND
RX
OCP
/BD
SS
/OLP
A
B
For ErrAmp, Sanken SE series device recommended
For SI, Sanken linear regulator IC recommended
CX
ROCP
28103.30-5
next