鉂?/div>
Hi-Rel processing available
General Description
The HV72 is a low-voltage serial to high-voltage parallel convert-
ers with push-pull outputs. It is especially suitable for use as a
symmetric row driver in AC thin-film electroluminescent (ACTFEL)
displays.
When the data reset pin (DR
IO
) is at logic high, it will reset all the
outputs of the internal shift register to zero. At the same time, the
output of the shift register will start shifting a logic high from the
least significant bit to the most significant bit. The DR
IO
can be
triggered at any time. The DIR and SHIFT pins control the
direction of data shift through the device. When DIR is at logic
high, DR
IOA
is the input and DR
IOB
is the output. When DIR is
grounded, DR
IOB
is the input and the DR
IOA
is the output. See the
Output Sequence Operation Table for output sequence. The
POL and OE pins perform the polarity select and output enable
function respectively. Data is loaded on the low to high transition
of the clock. A logic high will cause the output to swing to V
PP
if
POL is high, or to GND if POL is low. All outputs will be in High-
Z state if OE is at logic high. Data output buffers are provided for
cascading devices.
Absolute Maximum Ratings
Supply voltage, V
DD1
Supply voltage, V
PP
Logic input levels
Continuous total power dissipation
2
Plastic
Ceramic
Operating temperature range
Storage temperature range
Lead temperature 1.6mm (1/16 inch)
from case for 10 seconds
-0.5V to +7V
-0.5V to +260V
-0.5V to V
DD
+0.5V
1200mW
1900mW
Plastic
-40擄C to +85擄C
Ceramic -55擄C to +125擄C
-65擄C to +150擄C
260擄C
Notes:
1. All voltages are referenced to GND.
2. For operation above 25擄C ambient derate linearly to maximum operating tem-
perature at 20mW/擄C for plastic and at 19mW/擄C for ceramic.
02/96/022
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.
1
SUPERTEX
1
2
3
4
5
6
7
