Instruments that features Auto-Track鈩?/div>
Sequencing. Auto-Track simplifies the
sequencing of supply voltages in power
systems by enabling modules to track each
other, or any other external voltage, during
power up and power down.
Although small in size (0.87 in
脳
0.5 in),
these modules are rated for up to 6 A of
output current, and are an ideal choice in
applications where space, performance,
and a power-up sequencing capability are
important attributes.
The series operates from an input
voltage of 12-V to provide step-down
conversion to a wide range of output volt-
ages. The output voltage of the W-suffix
device may set to any voltage over the
adjust range, 1.2 V to 5.5 V. The L-suffix
device has an adjustment range of 0.8 V
to 1.8 V. The output voltage is set within
the adjustment range using a single exter-
nal resistor.
Other operating features include an
on/off inhibit, output voltage adjust (trim),
and output over-current protection. For
high efficiency these parts employ a syn-
chronous rectifier output stage.
Target applications include telecom,
industrial, and general purpose circuits,
including low-power dual-voltage systems
that use a DSP, microprocessor, ASIC, or
FPGA.
Pin Configuration
Pin
1
2
3
4
5
6
Function
GND
Track
V
in
Inhibit *
V
o
Adjust
V
out
* Denotes negative logic:
Open
= Normal operation
Ground = Function active
ck鈩?/div>
o-Tra n g
Aut
ci
quen
Se
Standard Application
Track
1
2
6
V
OUT
V
IN
3
4
PTH12050
(Top View)
5
C
3
100 碌F
(Optional)
C
1
100 碌F
(Required)
C
2
10 碌F
Ceramic
R
SET
1 %,
(Required)
Inhibit
GND
GND
Rset = Required to set the output voltage higher than
the lowest value. (See spec. table for values)
C
1
= Required 100 碌F capacitor
C
2
= 10 碌F ceramic capacitor. Required for output
voltages 3.3 V and higher
C
3
= Optional 100 碌F capacitor
For technical support and further information, visit http://power.ti.com
next