Z.C.
Z.C. : Zero-cross circuit
鉂?/div>
( ) : Typical dimensions
*1 Sine wave, practical value, Refer to Fig.1, 2
*2 50Hz sine wave, start at Tj=25藲C
*3 AC60Hz, for 1 min, 40 to 60%RH
Isolation voltage measuring method
1) Dielectric withstand voltage tester with zero cross circuit shall be used.
2) The applied voltage waveform shall be sine wave.
3) Voltage shall be applied between input and output.
(Input and output terminals shall all be shorted respectively.)
Notice
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Internet Internet address for Electronic Components Group http://www.sharp.co.jp/ecg/