MT9M001 - 1/2-Inch Megapixel Digital Image Sensor
Features
1/2-Inch Megapixel CMOS Digital Image Sensor
MT9M001C12STM (Monochrome)
For the latest data sheet, refer to Micron鈥檚 Web site:
www.micron.com\imaging
Features
鈥?DigitalClarity鈩?CMOS Imaging Technology
鈥?Array Format (5:4): 1,280H x 1,024V (1,310,720 active
pixels). Total (incl. dark pixels): 1,312H x 1,048V
(1,374,976 pixels)
鈥?Frame Rate: 30 fps progressive scan; programmable
鈥?Shutter: Electronic Rolling Shutter (ERS)
鈥?Window Size: SXGA; programmable to any smaller
format (VGA, QVGA, CIF, QCIF, etc.)
鈥?Programmable Controls: Gain, frame rate, frame
size
Table 1:
Key Performance Parameters
Typical Value
1/2-inch (5:4)
6.66mm(H) x 5.32mm(V)
1,280H x 1,024V
5.2碌m x 5.2碌m
Electronic rolling shutter (ERS)
48 MPS/48 MHz
30 fps progressive scan;
programmable
10-bit, on-chip
2.1 V/lux-sec
68.2dB
45dB
3.0V
鈭?/div>
3.6V, 3.3V nominal
325mW at 3.3V;
Standby 275碌W
0擄C to +70擄C
48-pin CLCC
Parameter
Optical format
Active imager size
Active pixels
Pixel size
Shutter type
Maximum data rate/
master clock
Frame
SXGA
rate
(1280 x 1024)
ADC resolution
Responsivity
Dynamic range
SNR
MAX
Supply voltage
Power consumption
Operating temperature
Packaging
Applications
鈥?Digital still cameras
鈥?Digital video cameras
鈥?PC cameras
The Micron
廬
Imaging MT9M001 is an SXGA-format
with a 1/2-inch CMOS active-pixel digital image sen-
sor. The active imaging pixel array of 1,280H x 1,024V. It
incorporates sophisticated camera functions on-chip
such as windowing, column and row skip mode, and
snapshot mode. It is programmable through a simple
two-wire serial interface.
This megapixel CMOS image sensor features Digital-
Clarity鈥擬icron鈥檚 breakthrough low-noise CMOS
imaging technology that achieves CCD image quality
(based on signal-to-noise ratio and low-light sensitiv-
ity) while maintaining the inherent size, cost, and inte-
gration advantages of CMOS.
General Description
The sensor can be operated in its default mode or pro-
grammed by the user for frame size, exposure, gain set-
ting, and other parameters. The default mode outputs
an SXGA-size image at 30 frames per second (fps). An
on-chip analog-to-digital converter (ADC) provides 10
bits per pixel. FRAME_VALID and LINE_VALID signals
are output on dedicated pins, along with a pixel clock
that is synchronous with valid data.
Ordering Information
Table 2:
Available Part Numbers
Description
46-pin CLCC
Part Number
MT9M001C12STM
80a3e031
MT9M001_DS_1.fm - Rev. C 7/05 EN
1
Micron Technology, Inc., reserves the right to change products or specifications without notice.
漏2004 Micron Technology, Inc. All rights reserved.
Products and specifications discussed herein are subject to change by Micron without notice.
next