鈥?/div>
Connections and Setup
This section provides a step-by-step guide to the func-
tions and operation of these EV kits.
1) Connect a DC supply set to +3V (through an amme-
ter, if desired) to the V
CC
and GND terminals on the
EV kit.
2) Apply +3V to the
SHDN
control input.
3) Turn on the DC supply. The supply current should
read about 13.5mA.
4) Connect the VCO output to a spectrum analyzer
with a 50鈩?coaxial cable (minimize length).
5) Apply a variable DC voltage to the TUNE input
(+0.4V to +2.4V).
6) Check f
MIN
and f
MAX
on the spectrum analyzer by
varying the tuning voltage.
7) Apply a variable DC voltage to the MOD input
(+0.4V to +2.4V).
8) Check modulation peak frequency deviation on the
spectrum analyzer by varying the modulation volt-
age.
9) Check the output power level (-5dBm typ).
4
1
Component Suppliers
SUPPLIER
Murata Electronics
Taiyo Yuden
PHONE
800-831-9172
408-573-4150
FAX
814-238-0490
408-573-4159
Note:
Please indicate that you are using the MAX2754 when
contacting these component suppliers.
Quick Start
The MAX2754 EV kit is fully assembled and factory test-
ed. Follow the instructions in the
Connections and
Setup
section for proper device evaluation.
________________________________________________________________
Maxim Integrated Products
1
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim鈥檚 website at www.maxim-ic.com.
1
2
