LCM1210R2
Molded
Chip Inductor
.126" 鹵 .012"
3.20mm 鹵 .3
.086" 鹵 .012"
2.20mm 鹵 .3
.020" 鹵 .008"
.5 mm
.098" 鹵 .012"
2.50mm 鹵 .3
.067" 鹵.003"
1.7 mm
FEATURES
Small molded chip inductor
Special ferrite core ensures stable inductance against
temperature humidity
Broad inductance range
High Q
Highly reliable
Excellent for flow, re-flow soldering, and soldering iron
CHARACTERISTICS
INDUCTANCE RANGE .01 碌H to 330 碌H
APPLICATIONS
TV's, VCR's, and audio equipment
Disk drives and other computer periferals
Personal computers
Electronic control boards for automobiles
Telecommunication devices
TOLERANCE 10% over entire range. 5% available upon request
CURRENT RATING Based on current flow and temperature rise of 20擄C maximum at 80擄C ambient temperature.
TESTING PROCEDURE Inductance, Q, and SRF measured by HP4191A Impedance Analyzer with 16092A Test Clip at specified
frequency. DCR measured with digital milliohms meter.
DIELECTRIC STRENGTH 1000 v
olts DC between both terminals and package of coil for 5 seconds.
SOLDERABILITY
95% of the terminal is covered with solder. Please refer to page 2 for soldering recommendations.
260擄C for 10 seconds after 120擄C preheat cycle for 5 minutes.
-25擄C to 85擄C where inductance and Q shall not change more than 20%.
SOLDERING HEAT: RESISTANCE
TEMPERATURE CHARACTERISTIC
STORAGE TEMPERATURE Store at normal tempera
ture (-5擄C to + 35擄C) and normal humidity(85% RH max) inoriginal package.
Do not expose to direct sunlight or harmful gas. This inductor can maintain its characteristics in a storage temperature from
-40擄C to + 125擄C for a period of 90 days.
HUMIDITY CHARACTERISTICS There is no change in performance at a humidity condition of 90-95% RH in 500 hours.
Measurement shall be made after 1 hour stabilization at room temperature.
HEAT RESISTANCE Subjected to 100擄C for 1000 hours without change in appearance, deformation, or perf ormance.
Measurement shall be made after 1 hour stabilization at room temperature.
THERMAL SHOCK Subjected to 100 c
ycles at the following temperature range without a change in performance: -25擄C for
1 hour + 100擄C for 1 hour. Measurement shall be made after 1 hour stabilazation at room temperature.
TERMINAL STRENGTH
Meets 3 lbs. pull test
RESISTANCE TO SOLVENT No change in appearance when dipped into alcohol or fr on for 3 minutes.
e
MARKING
Part is mar ked with inductance value in EIA code.
Tape and Reel only.
PACKAGING
1
