nous static RAM designed to provide a burstable, high-perfor-
mance, secondary cache for the Pentium鈩? 680X0鈩? and
PowerPC鈩?microprocessors. It is organized as 65,536 words
by 32 bits, fabricated with
ICSI
's advanced CMOS technology.
The device integrates a 2-bit burst counter, high-speed SRAM
core, and high-drive capability outputs into a single monolithic
circuit. All synchronous inputs pass through registers con-
trolled by a positive-edge-triggered single clock input.
Write cycles are internally self-timed and are initiated by the
rising edge of the clock input. Write cycles can be from one to
four bytes wide as controlled by the write control inputs.
Separate byte enables allow individual bytes to be written.
BW1
controls DQ1-DQ8,
BW2
controls DQ9-DQ16,
BW3
controls DQ17-DQ24,
BW4
controls DQ25-DQ32, conditioned
by
BWE
being LOW. A LOW on
GW
input would cause all bytes
to be written.
Bursts can be initiated with either
ADSP
(Address Status
Processor) or
ADSC
(Address Status Cache Controller) input
pins. Subsequent burst addresses can be generated internally
by the IS61SF6432 and controlled by the
ADV
(burst address
advance) input pin.
Asynchronous signals include output enable (OE), sleep mode
input (ZZ), clock (CLK) and burst mode input (MODE). A HIGH
input on the ZZ pin puts the SRAM in the power-down state.
When ZZ is pulled LOW (or no connect), the SRAM normally
operates after three cycles of the wake-up period. A LOW
input, i.e., GND
Q
, on MODE pin selects LINEAR Burst. A V
CCQ
(or no connect) on MODE pin selects INTERLEAVED Burst.
鈥?/div>
ICSI reserves the right to make changes to its products at any time without notice in order to improve design and supply the best possible product. We assume no responsibility for any errors
which may appear in this publication. 漏 Copyright 2000, Integrated Circuit Solution Inc.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
