鈥?/div>
Floating channel up to +600 or +1200V
Soft over-current shutdown
Synchronization signal to synchronize shut down with the other phases
Integrated desaturation detection circuit
Two stage turn on output for di/dt control
Separate pull-up/pull-down output drive pins
Matched delay outputs
Under voltage lockout with hysteresis band
Product Summary
V
OFFSET
IO+/- (typ)
V
OUT
Deadtime matching (max)
Deadtime (typ)
Desat blanking time (typ)
DSH, DSL input voltage
threshold (typ)
Soft shutdown time (typ)
600V or
1200V max.
2.0 A / 3.0A
10.4V - 20V
75 nsec
330
nsec
3
碌sec
8.0 V
9.25
碌sec
Description
The IR2114/21141/2214/IR22141 gate driver family is suited to drive a single
half bridge in power switching applications. The high gate driving capability (2A
source, 3A sink) and the low quiescent current enable bootstrap supply
techniques in medium power systems. These drivers feature full short circuit
protection by means of the power transistor desaturation detection and manages
all the half-bridge faults by turning off smoothly the desaturated transistor
through the dedicated soft shut down pin, therefore preventing over-voltages and
reducing EM emissions. In multi-phase system IR2114/21141/2214/IR22141
drivers communicate using a dedicated local network (SY_FLT and FAULT/SD
signals) to properly manage phase-to-phase short circuits. The system controller
may force shutdown or read device fault state through the 3.3 V compatible
CMOS I/O pin (FAULT/SD). To improve the signal immunity from DC-bus noise,
the control and power ground use dedicated pins enabling low-side emitter
current sensing as well. Undervoltage conditions in floating and low voltage
circuits are managed independently.
Package
24-Lead SSOP
Typical connection
DC+
15 V
VCC
VB
HOP
HON
SSDH
LIN
DC BUS
(1200V)
IR2214
HIN
uP,
Control
FAULT/SD
FLT_CLR
SY_FLT
DSH
VS
Motor
LOP
LON
SSDL
DSL
VSS
COM
DC-
1