Operation Mode錛?/div>
DUAL銆丗AST銆丼LOW銆両DLE銆丼LEEP Mode.
With WDT (WATCH DOG TIMER) to prevent deadlock condition.
24~48 bit Bi-directional I/O port. Mask Option can select PUSH-PULL or OPEN DRAIN output
mode for each I/O pin. 24 of them are shared with LCD segment pins.
The new built-in hardware auto scan keyboard (4*20) (shared with LCD SEG Pin) not only reduces
the hardware cost, but also reduces the firmware effort.
One built-in OP comparator.
One Voltage Detector with two detecting threshold Vth. (Vth=2.4V/2.4v).
Users can select any one of four LCD configuration---32COM*128SEG LCD , 48COM*112SEG
LCD , 64COM*96SEG LCD or 80COM*80SEG LCD. All of LCD configuration are B
TYPE(please refer to HE80000 user鈥檚 manual, section 4.3.9 LCD control register)銆侷t is built-in
type-III regulator, the LCD can display stably. The highest LCD voltage LVP must small than 8.5
Volt.
LCDC[7:0]=[錛嶏紞錛岹
GGBE]銆侴
: gray level control銆丅 :blank(1)銆丒: enable(1)銆?/div>
Normally, The LCD refresh rate is around 64 Hz. But for this IC, 32 COM configuration ~= 170 Hz
and 48 COM configuration ~= 110 Hz
One 7-bit current-type DAC output.
PWM device. (No Rate Selection, connect with VDD & PWMP)
1
V2.43E
next