1. Uses 3-pin connector terminal
2. High sensing accuracy (Slit width : 0.5mm)
3. Wide gap between light emitter and detector (5mm)
4.
1. Copiers, Printers
2. Facsimiles
MOLEX-JAPAN CO., LTD.
鈭?/div>
3.5
11鹵0.1 12鹵0.1
g
Unspecified tolerances shall be as follows
Dimensions (d)
d<4.0
4.0<=d<16.0
16.0<=d
Internal connection diagram
1
Tolerance
鹵0.2
鹵0.3
鹵0.5
Voltage regulator
Amp.
2
5.5鹵1
* "OPIC" (Optical IC) is a trademark of the SHARP Corporation.
An OPIC consists of a light-detecting element and signal-processing circuit
integrated onto a single chip.
Notice
In the absence of confirmation by device specification sheets, SHARP takes no responsibility for any defects that may occur in equipment using any SHARP
devices shown in catalogs, data books, etc. Contact SHARP in order to obtain the latest device specification sheets before using any SHARP device.
Internet Internet address for Electronic Components Group http://www.sharp.co.jp/ecg/
5
6
7
QB
QD
*1 Collector-emitter voltage of output transistor.
*2 Collector current of output transistor.
*3 The connector should be plugged in/out at normal temperature.
11
B
A
QZ
D
8
9
X
E
QA
Y
Z
1
2
3
4
9 6
1
3
2
3
V
CC
GND
V
O
1
2
3
4
