2.54mm Pitch Miniature Connector for Flexible Board
FH1 Series
sFeatures
1. 2.54mm FPC and FFC Connector
The contact pitch is 2.54mm.
2. Contact Reliability
This connector assures high contact reliability for high voltage
contact.
3. Eighteen Types of Contact Numbers
This connector consists of 18 kinds of 8, 9, 10, 11, 12, 13, 14,
15, 15, 17, 18, 19, 20, 21, 22, 27, and 29 contacts.
sApplications
HDD, facsimiles, printers, VTR, etc.
sProduct
Specifications
Rating
Rated Current: 1A
Rated Voltage: 200V AC
Operating Temperature Range:_40~+85莽 (Note 1) Storage Temperature Range:_10~+60莽 (Note 2)
Operating Humidity Range:Relative humidity, 90% max. Storage Humidity Range: Relative humidity, 90% max.
(Not dewed)
Applicable FPC
Item
1. Insulation Resistance
2. Withstand voltage
3. Contact Resistance
4. Mechanical operation
5. Vibration
6. Shock
7. Moisture Resistance in Steady State
8. Temperature Cycle
5000M酶 min.
Neither short or breakdown should occur.
20m酶max.
蟺 FPC conductor resistance included
Contact resistance : 40m酶 max.
No part should be broken, cracked or loosened
No part should be broken, cracked or loosened
No part should be broken, cracked or loosened
Insulation resistance: 500M酶 min.
No part should be broken, cracked or loosened
Frequency: 10~55Hz and full amplitude 1.50mm in 3 directions for 2 hours, respectively
Acceleration: 490m/S2, duration: 11ms, sine half-wave: in 3 directions for 3 times, respectively
Exposed to temperature 40莽 and humidity 90~95% for 96 hours
5 cycles under conditions as follows;
Temperature: _55莽
隆
+5~+35
隆
85
隆
+5~+35莽
Time: 30
隆
10~15
隆
30~10~15 minutes
9.Resistance to Soldering heat Neither appearance should be deformed nor contact remarkably loosened. Automatic soldering: 260莽艙 for 10 seconds
Note 1. Temperature rise included when energized
Note 2. This storage indicates a long-term storage state for the unused product before board mounted.
The operating temperature and humidity ranges are applied to the non-energized state after the connector has been installed
in the board.
Note 3. The above standards represent this series. The individual formal agreement should be based on the "Specification".
30 cycles
t=0.13~0.3 Tin plating
Specification
Measured at 500V DC
500V AC for 1 minute
Measured at DC 1A
Condition
(Not dewed)
D2
1
2
3
4
