www.fairchildsemi.com
FAN53180
6-Bit VID Controlled 2-4 Phase DC-DC Controller
Features
鈥?Precision Multi-Phase DC-DC Core Voltage Regulation
鈥?鹵14.5mV Output Voltage Accuracy Over Temperature
鈥?Differential Remote Voltage Sensing
鈥?Selectable 2, 3, or 4 Phase Operation
鈥?Up to 1MHz per Phase Operation (4MHz ripple
Frequency)
鈥?Lossless Inductor Current Sensing for Loadline
Compensation
鈥?External Temperature Compensation
鈥?Accurate Load-Line Programming (Meets Intel VRM/
VRD10 CPU Speci鏗乧ations)
鈥?Accurate Channel-Current Balancing for Thermal
Optimization and Layout Compensation
鈥?Convenient 12V Supply Biasing
鈥?6-bit Voltage Identi鏗乧ation (VID) Input
鈥?0.8375V to 1.600V in 12.5mV Steps
鈥?Dynamic VID Capability with Fault-Blanking for
glitch-less Output voltage Changes
鈥?Adjustable Over Current Protection with Programmable
Latch-Off Delay
鈥?Over-Voltage Protection 鈥?Internal OVP Crowbar
Protection
General Description
The FAN53180 is a multi-phase DC-DC controller for
implementing high-current, low-voltage, CPU core power
regulation circuits. It is part of a chipset that includes
external MOSFET drivers and power MOSFETS. The
FAN53180 drives up to 4 synchronous-recti鏗乪d buck
channels in parallel. The multi-phase buck converter
architecture uses interleaved switching to multiply ripple
frequency by the number of phases and reduce input and
output ripple currents. Lower ripple results in fewer com-
ponents, lower component cost, reduced power dissipation,
and smaller board area.
The FAN53180 features a high bandwidth control loop to
provide optimal response to load transients. The FAN53180
senses current using lossless techniques: Phase current is
measured through each of the output inductors. This current
information is summed, averaged and used to set the loadline
of the output via programmable 鈥渄roop鈥? The droop is
temperature compensated to achieve precise loadline
characteristics over the entire operating range. Additionally,
individual phase current is measured using the R
DS-ON
of the
low-side MOSFET鈥檚. This information is used to dynami-
cally balance/steer per-phase current. The phase currents are
also summed and averaged for over-current detection.
Dynamic-VID technology allows on-the-鏗倅 VID changes
with controlled, glitch-less output. Additionally, short-circuit
protection, adjustable current limiting, over-voltage protec-
tion and power-good circuitry combine to ensure reliable and
safe operation. The operating temperature range is 0擄C to
+85擄C and the operating voltage is a single +12V supply,
simplifying design. The FAN53180 is available in a
TSSOP-28 package.
Applications
鈥?Computer DC/DC Converter VRM/VRD10.0
鈥?Computer DC/DC Converter VRM/VRD9.X
鈥?High Current, Low Voltage DC/DC Rail
System Block Diagram
V
IN
桅1
FAN53418
桅2
FAN53180
桅3
V
IN
V
OUT
桅4
FAN53418
REV. 1.0.0 6/10/03