鈥?Spread Aware鈩?/div>
up to 100-/133-MHz frequencies, and have higher drive than
the -1 devices. All parts have on-chip PLLs that lock to an input
clock on the REF pin. The PLL feedback is on-chip and is
obtained from the CLKOUT pad.
The CY23S09 has two banks of four outputs each, which can
be controlled by the Select inputs as shown in the Select Input
Decoding table on page 2. If all output clocks are not required,
Bank B can be three-stated. The select inputs also allow the
input clock to be directly applied to the outputs for chip and
system testing purposes.
The CY23S09 and CY23S05 PLLs enter a power-down mode
when there are no rising edges on the REF input. In this state,
the outputs are three-stated and the PLL is turned off, resulting
in less than 12.0
碌A
of current draw (for commercial temper-
ature devices) and 25.0
碌A
(for industrial temperature
devices). The CY23S09 PLL shuts down in one additional
case, as shown in the table below.
Multiple CY23S09 and CY23S05 devices can accept the same
input clock and distribute it. In this case, the skew between the
outputs of two devices is guaranteed to be less than 700 ps.
All outputs have less than 200 ps of cycle-to-cycle jitter. The
input to output propagation delay on both devices is
guaranteed to be less than 350 ps, and the output to output
skew is guaranteed to be less than 250 ps.
The CY23S05/CY23S09 is available in two different configu-
rations, as shown in the ordering information on page 6. The
CY23S05-1/CY23S09-1 is the base part. The CY23S05-1H/
CY23S09-1H is the high-drive version of the -1, and its rise
and fall times are much faster than -1.
Functional Description
The CY23S09 is a low-cost 3.3V zero delay buffer designed to
distribute high-speed clocks and is available in a 16-pin SOIC
package. The CY23S05 is an eight-pin version of the
CY23S09. It accepts one reference input, and drives out five
low-skew clocks. The -1H versions of each device operate at
Block Diagram
PLL
REF
MUX
CLKOUT
CLKA1
CLKA2
CLKA3
CLKA4
CLKB1
Select Input
Decoding
S1
CLKB2
CLKB3
Pin Configuration
SOIC/TSSOP/SSOP
Top View
REF
CLKA1
CLKA2
V
DD
GND
CLKB1
CLKB2
S2
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
CLKOUT
CLKA4
CLKA3
V
DD
GND
CLKB4
CLKB3
S1
S2
CY23S09
CLKB4
CY23S09
REF
PLL
CLKOUT
CLK1
CLK2
CLK3
CLK4
SOIC
Top View
REF
CLK2
CLK1
GND
1
2
3
4
8
7
6
5
CLKOUT
CLK4
V
DD
CLK3
CY23S05
CY23S05
Cypress Semiconductor Corporation
Document #: 38-07296 Rev. *B
鈥?/div>
3901 North First Street
鈥?/div>
San Jose
鈥?/div>
CA 95134 鈥?408-943-2600
Revised December 22, 2002
1
2
3
4
5
6
7
8
9
