鈭?/div>
C1
C4
Vo
For acutual usage, Please kindly evaluate and confirm our part mounted in your product,
Especially, Please make sure to confirm whether the load current exceed Max. rated current
by using the current probe.
Output Current I15(mA)
Output Current I5(mA)
Surface Temperature Rising
Surface Temperature Rising
Temperature Rising
鈭員(擄C)
20
18
16
14
12
10
8
6
4
2
0
Surface Temperature Rising
Temperature Rising
鈭員(擄C)
20
18
16
14
12
10
8
6
4
2
0
(5V output) (I15=0mA, Vi=141V)
External components setting
FUSE: Fuse
C1: Capacitor for input
voltage smoothing
C2: For noise terminal
voltage reduction
C3: Capacitor for Output
(15V output)
C4: Capacitor for Output
(5V output)
L1: Choke coil
D1: Rectifier diode
Please make sure to use quick acting fuse 1A / Please use the fuse resistance for R2.
Capacitance : 33碌F鈭?20碌F Rated voltage : 450V or higher
Ripple current is 0.13Arms above.
Capacitance : 0.1碌F鈭?.22碌F Rated voltage : 450V or higher
Film capacitor or ceramic capacitor. Reduce the noise terminal voltage.
The constant value should be evaluated in the set.
Capacitance : 220碌F鈭?000碌F Rated voltage : 35V or higher,
ESR is 0.16鈩?max. Ripple current is 0.4Arms above.
Output ripple voltage is influenced. Please evaluate it in the actual se
Capacitance : 220碌F鈭?000碌F Rated voltage : 16V or higher,
ESR is 0.25鈩?max. Ripple current is 0.4Arms above.
Output ripple voltage is influenced. Please evaluate it in the actual set.
L : 1mH Allowable current : 600mA or higher.
Please use the one that is hard to be magnetic saturated even in the high temperature.
In the absolute maximum ratings, the reverse peak voltage should be
800V or higher, the average rectifying current should be 1A or higher,and
the peak surge current should be 40A or higher.
For rush current, to use the large capacity diode for surge current is recommended.
(15V output) (I5=0mA, Vi=141V)
0
20
40
60
80
0
50 100 150 200 250 300 350
Output Current I15(mA)
Output Current I5(mA)
R1: Rush current limiting
resistance
R2: For noise terminal
ZNR: Varistor
Limiting resistance must be used because rush current at powering up is
applied in proportion to the C1 capacitance.Please determine the resistance value after confirming
the rising characteristics of the module at powering up.
10鈩︹埣22鈩?1/4W Reduce the noise terminal voltage.Please set it,if necessary.
The constant value should be evaluated in set.
Varistor must be used. It protects this part from lightning surge andstatic electricity.
1/2