鈥?/div>
48 pin TSSOP and TVSOP package availability
Product Description (Cont.)
To ensure the high-impedance state during power up
or power down, OE should be tied V
DD
through a
pullup resistor; the minimum value of the resistor is
determined by the current-sinking capability of the OE
driving device.
Output circuitry is dynamically controlled, which,
during output transitions, initially lowers the output
impedance to effectively drive the load and,
subsequently, raises the impedance to reduce noise.
Figure 1 shows typical VOL vs. IOL and VOH vs IOH
curves to illustrate the output impedance and drive
capability of the circuit.
Product Description
The AVC16245 is a 16-bit transceiver featuring non-
inverting buffer/line driver with 3-state bus compatible
outputs in both send and receive directions.
This device can be used as two 8-bit transceivers or
one 16-bit transceiver. It allows data transmission
from the A bus to the B bus or from the B bus to the A
bus, depending on the logic level at the direction-
control (DIR) inputs. The output enable (OE) inputs
can be used to disable the device so that the buses
are effectively isolated.
This product is designed to have an extremely low
propagation delay and a minimum amount of power
consumption.
Pin Configuration
Block Diagram
1DIR 1
48
1A1
47
2
1B1
1OE
2A1 36
13
2B1
2DIR 24
25
2OE
To seven other channels
To seven other channels
1DIR
1B1
1B2
V
SS
1B3
1B4
V
DD
1B5
1B6
V
SS
1B7
1B8
2B1
2B2
V
SS
2B3
2B4
V
DD
2B5
2B6
V
SS
2B7
2B8
2DIR
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
48
47
46
45
44
43
42
41
40
39
38
37
36
35
34
33
32
31
30
29
28
27
26
25
1OE
1A1
1A2
V
SS
1A3
1A4
V
DD
1A5
1A6
V
SS
1A7
1A8
2A1
2A2
V
SS
2A3
2A4
V
DD
2A5
2A6
V
SS
2A7
2A8
2OE
INTERNATIONAL MICROCIRCUITS, INC. 525 LOS COCHES ST.
MILPITAS, CA 95035. TEL: 408-263-6300. FAX 408-263-6571
http://www.imicorp.com
Rev.1.0
AVC16245
9/5/2000
Page 1 of 11