ADVANCE INFORMATION
8x930Hx
UNIVERSAL SERIAL BUS HUB
PERIPHERAL CONTROLLER
s
USB Hub with One Upstream, One
Internal Downstream, and Three
External Downstream Ports on HD/HE
Parts or Four on HF/HG Parts
鈥?Complete Universal Serial Bus Speci-
fication 1.0 Compatibility
鈥?Serves as both USB Hub and USB
Embedded Function (Internal Port)
s
USB Hub
鈥?Connectivity Management
鈥?Downstream Device
Connect/Disconnect Detection
鈥?Power Management, Including
Suspend and Resume
鈥?Bus Fault Detection and Recovery
鈥?Full and Low Speed Downstream
Device Support
s
Output Pin for Port Power Switching
s
Input Pin for Overcurrent Detection
s
USB Embedded Function
鈥?Supports Isochronous and
Non-isochronous Data
s
On-chip USB Transceivers
s
Serial Bus Interface Engine (SIE)
鈥?Packet Decoding/Generation
鈥?CRC Generation and Checking
鈥?NRZI Encoding/Decoding and
Bit-stuffing
s
Hub FIFO Data Buffers
鈥?One Pair of 16-byte Transmit and
Receive FIFOs
鈥?One 1-byte Transmit Register
s
Embedded Function FIFO Data Buffers
鈥?Three Pairs of 16-byte Transmit and
Receive FIFOs
鈥?One Pair of Configurable Transmit
and Receive FIFOs (1 Kbyte total)
s
Automatic Transmit/Receive FIFO
Management
s
Three USB Interrupt Vectors
鈥?Endpoint Transmit/Receive Done
鈥?Start of Frame/Hub Endpoint Done
鈥?Global Suspend/Resume
s
Low Clock Mode
s
User-selectable Configurations
鈥?External Wait State
鈥?External Address Range
鈥?Page Mode
s
Real-time Wait Function
s
256-Kbyte External Code/Data Memory
Space
s
On-chip ROM Options
鈥?0, 8, or 16 Kbytes
s
1024 bytes On-chip Data RAM
s
Four Input/Output Ports
s
Standard MCS
廬
51 UART
s
Power-saving Idle and Powerdown
Modes
s
Register-based MCS
廬
251 Architecture
s
Code-compatible with MCS 51 and
MCS 251 Microcontrollers
s
12-MHz Crystal Operation
The 8x930Hx USB hub peripheral controller is based on the MCS 251 microcontroller. It consists of standard
8XC251Sx peripherals plus a USB module. The USB module provides both USB hub and USB embedded
function capabilities. The 8x930Hx supports USB hub functionality, embedded function, suspend/resume
modes, isochronous/non-isochronous transfers, and it is fully USB rev 1.0 specification compliant. The USB
module contains one internal and three (or four) external downstream ports and integrates the USB trans-
ceivers, serial bus interface engine (SIE), hub interface unit (HIU), function interface unit (FIU), and
transmit/receive FIFOs. The 8x930Hx uses the standard instruction set of the MCS 251 architecture, which is
binary code compatible with the MCS 51 architecture.
COPYRIGHT 漏 INTEL CORPORATION, 1997
May 1997
Order Number: 272928-003