鈥?/div>
1000 Vdc isolation test voltage
Low input current requirement: 0.5mA
Low output saturation voltage: 0.1V typical
Low power consumption
Leadless chip carrier package
Faraday shield provides high common mode
rejection
DESCRIPTION
RECOMMENDED OPERATING CONDITIONS
PARAMETER
Input Current, Low
Level Each Channel
Input Current, High
Level Each Channel
Supply Voltage
V
CC
2.0
18
V
I
FH
0.5
5
mA
The 66053 optocoupler contains an infrared LED optically
coupled to a corresponding high gain darlington detector.
This unique optocoupler provides high CTR and low
leakage current over the full military temperature range (-
55擄C to + 125擄C). The 66053 is a 24 pin hermetically sealed
leadless chip carrier and is available in standard and
screened versions or tested to customer specifications.
SYMBOL
I
FL
MIN
MAX
2
UNITS
碌A(chǔ)
ABSOLUTE MAXIMUM RATINGS
Output current - I
O
...........................................................................................................................................................................................................................................................................
40mA
Output voltage - V
O
..................................................................................................................................................... -0.5 to 20V (1)
Supply voltage - V
CC
.................................................................................................................................................... -0.5 to 20V (1)
Output power dissipation .................................................................................................................................................. 50 mW (2)
Storage temperature ...............................................................................................................................................-65擄C to +150擄C
Operating temperature .............................................................................................................................................-55擄C to +125擄C
Lead solder temperature ....................................................................................................................................... 260擄C for 10 sec.
Peak input current (<1ms duration) .........................................................................................................................................20mA
Reverse input voltage - V
R
............................................................................................................................................................. 5V
Average input current - I
F
.................................................................................................................................................... 10mA (3)
Notes:
1.
2.
3.
The lowest total I
OH
over temperature is developed by keeping V
CC
as low as possible, but greater than 2.0 volts. The negative voltage at the
detector side should be applied to PIN 10.
Collector output power plus one fourth of the total supply power is total output power. Derate at 0.46mW/擄C above 25擄C.
Derate I
F
at 0.05mA /擄C above 25擄C.
Package Dimensions
NO. 1 LEAD
IDENTIFIER
Schematic Diagram
0.045
[1.143]
0.008
[.203]
RAD,TYP
2
Mii 66053
XXXXX
A
Vcc
15
Vo 14
0.020
(.508)
0.070
0.400+.010,-.055
[10.160 +.254,-.127]
[1.778]
0.050
[1.270]
0.035
[.889]
REF.
1
K
GND 10
MICROPAC INDUSTRIES, INC. OPTOELECTRONIC PRODUCTS DIVISION
鈥?/div>
725 E.Walnut Str., Garland, TX 75040
鈥?/div>
(972)272-3571
鈥?/div>
Fax (972)487-6918
www.micropac.com
E-MAIL: OPTOSALES @ MICROPAC.COM
1
2
