static RAM designed to provide a burstable, high-performance,
secondary cache for the i486鈩? Pentium鈩? 680X0鈩? and
PowerPC鈩?microprocessors. It is organized as 65,536 words
by 64 bits, fabricated with
ISSI
's advanced CMOS technology.
The device integrates a 2-bit burst counter, high-speed SRAM
core, and high-drive capability outputs into a single monolithic
circuit. All synchronous inputs pass through registers con-
trolled by a positive-edge-triggered single clock input.
Write cycles are internally self-timed and are initiated by the
rising edge of the clock input. Write cycles can be from one to
eight bytes wide as controlled by the write control inputs.
Separate byte enables allow individual bytes to be written.
BW1
controls I/O1-I/O8,
BW2
controls I/O9-I/O16,
BW3
controls I/
O17-I/O24,
BW4
controls I/O25-I/O32,
BW5
controls
I/O33-I/O40,
BW6
controls I/O41-I/O48,
BW7
controls I/O49-I/
O56,
BW8
controls I/O57-I/O64, conditioned by
BWE
being
LOW. A LOW on
GW
input would cause all bytes to be written.
Bursts can be initiated with either
ADSP
(Address Status
Processor) or
ADSC
(Address Status Cache Controller) input
pins. Subsequent burst addresses can be generated internally
by the IS61SP6464 and controlled by the
ADV
(burst address
advance) input pin.
Asynchronous signals include output enable (OE), sleep mode
input (ZZ), and burst mode input (MODE). A HIGH input on the
ZZ pin puts the SRAM in the power-down state. When ZZ is
pulled LOW (or no connect), the SRAM normally operates after
the wake-up period. A LOW input, i.e., GND
Q
, on MODE pin
selects LINEAR Burst. A V
DDQ
(or no connect) on MODE pin
selects INTERLEAVED Burst.
Copyright 漏 2004 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time
without notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to
obtain the latest version of this device specification before relying on any published information and before placing orders for products.
Integrated Silicon Solution, Inc. 鈥?1-800-379-4774
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
