鈥?/div>
High transmissivity polycarbonate material
UL94V-0 compliance
ESD protection (circuit isolation from front panel)
Wide viewing angle
Arrays reduce insertion costs
Secures to panel by press-fit
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Operating/Storage Temperature
鈥?0擄C to +100擄C
Dialight
Optopipe
Light Pipe Description
This Optopipe鈩?is mounted through the rear of the panel and is retained by press fit. The light pipe is not attached to
the PCB at any point but floats above it. The diffused light emitting surfaces appear bright and uniformly illuminated. The
recommended light sources are Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The light source鈥檚 emitting
surface should be located no more than 0.020" or 0.5mm from the Optopipe鈩? The SMT LEDs are mounted in a straight
line under the rear of the part on a 6.35 mm pitch. The light pipe material is water clear transmissive polycarbonate rated
UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe鈩?solutions for your applications.
Dialight Corporation 鈥?1501 Route 34 South 鈥?Farmingdale, NJ 07727 鈥?TEL: (732) 919-3119 鈥?FAX: (732) 751-5778 鈥ww.dialight.com
2-17
1
