鈮?/div>
1.2 and nominal power supply voltage.
Symmetry is defined as the pulse width (in percent of total period) measured at the 50% points of Q or Q (see timing definitions).
Jitter and other spurious outputs induced by externally generated electrical noise on V
CC
or mechanical vibration are not included in
this specification, except where noted. External voltage regulation and careful PCB layout are recommended for optimum perfor-
mance.
Applies to period jitter of Q and Q. Measurements are made with the Tektronix CSA803 signal analyzer with at least 1000 samples.
Linearity is a function of the percentage variation from a permitted linear deviation versus the amount of frequency tune range
(see
linearity definition).
One or more of the following United States patents apply: 4,616,197; 4,670,681; 4,760,352.
Over the range of 669.327 MHz 鹵25 ppm and the conditions of Note 1.
BLOCK DIAGRAM
V CC
V tune
SAW Oscillator
Buffer Amplifier
Q
_
Q
7.
8.
9.
10.
RF Monolithics, Inc.
Phone: (972) 233-2903
Fax: (972) 387-8148
RFM Europe
Phone: 44 1963 251383
Fax: 44 1963 251510
漏1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: info@rfm.com
http://www.rfm.com
OP4008B-041003
Page 1 of 5