音影先锋亚洲天堂网|电影世界尽头的爱完整版播放|国产 熟女 91|高清无码免费观看欧美日韩|韩国一区二区三区黄色录像|美女亚洲加勒比在线|亚洲综合网 开心五月|7x成人在线入口|成人网站免费日韩毛片区|国产黄片?一级?二级?三级

LUCL9500AGF-D Datasheet

  • LUCL9500AGF-D

  • High-Voltage Ringing SLIC for VolP Applications

  • 32頁

  • AGERE

掃碼查看芯片數據手冊

上傳產品規格書

PDF預覽

L9500A
High-Voltage Ringing SLIC for VoIP Applications
Preliminary Data Sheet
September 2001
Applications
(continued)
dc Loop Current Limit
Current limit may be chosen from two discrete values,
25 mA or 40 mA, depending on if V
PROG
is grounded
(25 mA) or left floating (40 mA). Note that there is a
12.5 k鈩?slope to the I/V characteristic in the current-
limit region; thus, once in current limit, the actual loop
current will increase slightly, as loop length decreases.
The above describes the active mode steady-state cur-
rent-limit response. There will be a transient response
of the current-limit circuit upon an on- to off-hook transi-
tion. Typical active mode transient current-limit
response is given in Table 19.
Table 19. Typical Active Mode On- to Off-Hook Tip/
Ring Current-Limit Transient Response
Parameter
dc Loop Current:
Active Mode
R
LOOP
= 100
鈩?/div>
On- to Off-hook
Transition t < 5 ms
dc Loop Current:
Active Mode
R
LOOP
= 100
鈩?/div>
On- to Off-hook
Transition t < 50 ms
dc Loop Current:
Active Mode
R
LOOP
= 100
鈩?/div>
On- to Off-hook
Transition t < 300 ms
Value
I
LIM
+ 60
Unit
mA
On-Hook Transmission Mode
If the magnitude of the primary battery is greater than
51 V, the magnitude of the open loop tip-to-ring open
loop voltage is clamped typically between 41 V and
49 V. If the magnitude of the primary battery is less
than a nominal 51 V, the overhead voltage will track the
magnitude of the battery voltage, i.e., the magnitude of
the open circuit tip-to-ring voltage will be 6 V to 8 V less
than battery. In the scan mode, overhead is unaffected
by V
OVH
.
Ring Mode
In the ring mode, to maximize ringing loop length, the
overhead is decreased to the saturation of the tip ring
drive amplifiers, a nominal 4 V. The tip to ground volt-
age is 1 V, and the ring to V
BAT1
voltage is 3 V. In the
ring mode, overhead is unaffected by V
OVH
.
During the ring mode, to conserve power, the receive
input at RCVN/RCVP is deactivated. During the ring
mode, to conserve power, the ACC amplifier in the
transmit direction at VITR is deactivated. However, the
AX amplifier at VTX is active during the ring mode; dif-
ferential ring current may be sensed at VTX during the
ring mode.
I
LIM
+ 20
mA
Loop Range
I
LIM
mA
The dc loop range is calculated using:
V
BAT2
鈥?/div>
V
OH
R
L
=
-------------------------------------
鈥?2R
P
鈥?R
DC
I
LIMI T
Overhead Voltage
Active Mode
Overhead is fixed to a nominal 7.0 V, which is adequate
for an on-hook transmission of 3.14 dBm into 900
鈩?/div>
with additional head room for a 500 mV PPM signal.
Scan Mode
If the magnitude of the primary battery is greater than
51 V, the magnitude of the open loop tip-to-ring open
loop voltage is clamped typically between 44 V and
51 V. If the magnitude of the primary battery is less
than a nominal 51 V, the overhead voltage will track the
magnitude of the battery voltage, i.e., the magnitude of
the open circuit tip-to-ring voltage will be 4 V to 6 V less
than battery. In the scan mode, overhead is unaffected
by V
OVH
.
V
BAT2
is typically applied under off-hook conditions for
power conservation and SLIC thermal considerations.
The L9500 is intended for short-loop applications and,
therefore, will always be in current limit during off-hook
conditions. However, note that the ringing loop length
rather than the dc loop length will be the factor to deter-
mine operating loop length.
22
Agere Systems Inc.

LUCL9500AGF-D相關型號PDF文件下載

掃碼下載APP，
一鍵連接廣大的電子世界。

在線人工客服

買家服務：
賣家服務：
技術客服：

0571-85317607

網站技術支持

13606545031

客服在線時間周一至周五
9:00-17:30

關注官方微信號，
第一時間獲取資訊。

建議反饋

聯系人：

聯系方式：

按住滑塊，拖拽到最右邊
>>
感謝您向阿庫提出的寶貴意見，您的參與是維庫提升服務的動力！意見一經采納，將有感恩紅包奉上哦！