音影先锋亚洲天堂网|电影世界尽头的爱完整版播放|国产 熟女 91|高清无码免费观看欧美日韩|韩国一区二区三区黄色录像|美女亚洲加勒比在线|亚洲综合网 开心五月|7x成人在线入口|成人网站免费日韩毛片区|国产黄片?一级?二级?三级

TDA7461ND Datasheet

  • TDA7461ND

  • CAR RADIO SIGNAL PROCESSOR

  • 230.75KB

  • 31頁

  • STMICROELECTRONICS   STMICROELECTRONICS

掃碼查看芯片數據手冊

上傳產品規格書

PDF預覽

TDA7461N
DESCRIPTION OF STEREODECODER
The stereodecoder part of the TDA7461N (see
Fig. 17) contains all functions necessary to de-
modulate the MPX signal like pilot tone depend-
ent MONO/STEREO switching as well as
鈥漵tereoblend鈥?and 鈥漢ighcut鈥?functions.
Adaptations like programmable input gain, roll-off
compensation, selectable deemphasis time con-
stant and a programmable fieldstrength input al-
low to use different IF devices.
Figure 18. Signals during stereodecoder鈥檚
softmute
SOFTMUTE
COMMAND
t
STD MUTE
t
Stereodecoder Mute
The TDA7461N has a fast and easy to control
RDS mute function which is a combination of the
audioprocessor softmute and the high-ohmic
mute of the stereodecoder. If the stereodecoder
is selected and a softmute command is sent (or
activated through the SM pin) the stereodecoder
will be set automatically to the high-ohmic mute
condition after the audio signal has been soft-
muted.
Hence a checking of alternate frequencies could
be performed. To release the system from the
mute condition simply the unmute command must
be sent: the stereodecoder is unmuted immedi-
ately and the audioprocessor is softly unmuted.
Fig. 18 shows the output signal V
O
as well as the
internal stereodecoder mute signal. This influ-
ence of Softmute on the stereodecoder mute can
be switched off by setting bit 3 of the Softmute
byte to 鈥?鈥? A stereodecoder mute command (bit
0, stereodecoder byte set to 鈥?鈥? will set the
stereodecoder in any case independently to the
high-ohmic mute state.
If any other source than the stereodecoder is se-
lected the decoder remains muted and the MPX
pin is connected to Vref to avoid any discharge of
the coupling capacitor through leakage currents.
Input Stages
The Ingain stage allows to adjust the MPX signal
to a magnitude of about 1Vrms internally which is
the recommended value. The 4.th order input fil-
ter has a corner frequency of 80kHz and is used
to attenuatespikes and noise and acts as an anti-
aliasing filter for the following switch capacitor fil-
ters.
Demodulator
In the demodulator block the left and the right
channel are separated from the MPX signal. In
this stage also the 19 kHz pilot tone is cancelled.
For reaching a high channel separation the
TDA7461N offers an I2C bus programmable roll-
off adjustment which is able to compensate the
V
O
D97AU638
t
lowpass behaviour of the tuner section. If the
tuner attenuation at 38kHz is in a range from
20.2% to 31% the TDA7461N needs no external
network before the MPX pin. Within this range an
adjustment to obtain at least 40dB channel sepa-
ration is possible.
The bits for this adjustment are located together
with the fieldstrength adjustment in one byte. This
gives the possibility to perform an optimization
step during the production of the carradio where
the channel separation and the fieldstrength con-
trol are trimmed.
Deemphasis and Highcut.
The lowpass filter for the deemphasis allows to
choose between a time constant of 50碌s and
75碌s (bit D7, Stereodecoder byte).
The highcut control range will be in both cases
t
HC
= 2
鈰?/div>
t
Deemp
. Inside the highcut control range
(between VHCH and VHCL) the LEVEL signal
is converted into a 5 bit word which controls the
lowpass time constant between t
Deemp
...3
鈰?/div>
t
Deemp
.
There by the resolution will remain always 5 bits
independently of the absolute voltage range be-
tween the VHCH and VHCL values.
The highcut function can be switched off by I2C
bus (bit D7, Fieldstrength byte set to 鈥?鈥?.
PLL and Pilot Tone Detector
The PLL has the task to lock on the 19kHz pilo-
tone during a stereo transmission to allow a cor-
rect demodulation. The included detector enables
the demodulation if the pilot tone reaches the se-
lected pilottone threshold VPTHST. Two different
thresholds are available. The detector output (sig-
nal STEREO, see block diagram) can be checked
17/31

TDA7461ND 產品屬性

  • 28

  • 集成電路 (IC)

  • 線性 - 音頻處理

  • -

  • 汽車信號處理器

  • 車載系統

  • 表面貼裝

  • 28-SOIC（0.295"，7.50mm 寬）

  • 28-SO

  • 管件

TDA7461ND相關型號PDF文件下載

掃碼下載APP，
一鍵連接廣大的電子世界。

在線人工客服

買家服務：
賣家服務：
技術客服：

0571-85317607

網站技術支持

13606545031

客服在線時間周一至周五
9:00-17:30

關注官方微信號，
第一時間獲取資訊。

建議反饋

聯系人：

聯系方式：

按住滑塊，拖拽到最右邊
>>
感謝您向阿庫提出的寶貴意見，您的參與是維庫提升服務的動力！意見一經采納，將有感恩紅包奉上哦！