PCnet Family Network Driver Installation Guide
b. An auto scan will be performed to detect the proper I/O base address
and DMA values automatically. However, please note that the IRQ
(interrupt vector) value will also be automatically detected, but cannot
be installed dynamically.
c. If you know the correct IRQ value, enter it in the interrupt vector field,
press the down arrow key to highlight the Apply box, and then press
<Enter>. Go to step 7 below to continue.
d. If you do not know the correct IRQ value, enter a guess (e.g., 5),
press the down arrow key to highlight the Apply box, and then press
<Enter>.
e. If you happen to guess the correct IRQ value, you will not get an IRQ
mismatch message and the installation process will continue. Go to
step 7 below to continue.
f. Most likely, you will get an IRQ mismatch. In this case, you need to
reboot the system and restart the installation process.
g. As the system comes up during the reboot you will get a
WARNING
message instructing you to run your setup again with a specified IRQ
value. Write this IRQ value down and restart the installation process
from step 1 above.
h. When you reach step 6.2 again, use the IRQ value you wrote down in
the interrupt vector field leaving the other two fields set to 0. Press the
down arrow key to highlight the Apply box, and then press <Enter>.
I. Go to step 7 below to continue.
__7
The following message will be displayed:
## Processing package information
## Processing system information
## Verifying package dependencies
Followed by:
## Installing part 1 of 1.
Followed by:
The following loadable modules will be configured now:
pnt
Module configuration is completed.
110