__12.2 For PCnet-ISA+, PCnet-ISA II, PCnet-32, PCnet-PCI adapter cards:
a. Leave the I/O base address and DMA values set to 0.
b. An auto scan will be performed to detect the proper I/O base address
and DMA values automatically. However, note that the IRQ
(interrupt vector) value will also be automatically detected, but cannot
be installed dynamically.
c. If you know the correct IRQ value, enter it in the interrupt vector field,
press the down arrow key to highlight the Apply box, and then press
<Enter>. Go to step 13 below to continue.
d. If you do not know the correct IRQ value, enter a guess (e.g., 5 ),
press the down arrow key to highlight the Apply box, and then press
<Enter>.
e. If you happen to guess the correct IRQ value, you will not get an IRQ
mismatch message and the installation process will continue. Go to
step 13 below to continue.
f. Most likely, you will get an IRQ mismatch. In this case, you need to re-
boot the system and restart the installation process.
g. As the system comes up during the reboot you will get a WARNING
message instructing you to run your setup again with a specified IRQ
value. Write this IRQ value down and restart the installation process
from step 1 above.
h. When you reach step 12.2 again, use the IRQ value you wrote down
and use it to fill in the interrupt vector field leaving the other two fields
set to 0. Press the down arrow key to highlight the Apply box, and
then press <Enter>.
i. Go to step 13 below to continue.
__13 The following message will be displayed:
## Installing part 1 of 1
Wait for the system to install the Unixware driver.
__14 The following message will be displayed:
Click Exit to terminate pkgadd
Click on the Exit button.
107