音影先锋亚洲天堂网|电影世界尽头的爱完整版播放|国产 熟女 91|高清无码免费观看欧美日韩|韩国一区二区三区黄色录像|美女亚洲加勒比在线|亚洲综合网 开心五月|7x成人在线入口|成人网站免费日韩毛片区|国产黄片?一级?二级?三级

MC33886 Datasheet

  • MC33886

  • 5.0 A H-Bridge

  • 451.79KB

  • Motorola   Motorola

掃碼查看芯片數據手冊

上傳產品規格書

PDF預覽

Freescale Semiconductor, Inc.
OUT1 and OUT2
These terminals are the outputs of the H-Bridge with
integrated output FET body diodes. The bridge output is
controlled using the IN1, IN2, D1, and D2 inputs. The outputs
have active current limiting above 6.5 A. The outputs also have
thermal shutdown (tri-state latch-OFF) with hysteresis as well
as short circuit latch-OFF protection.
A disable timer (time t
b
) incorporated to detect currents that
are higher than active current limit is activated at each output
activation to facilitate detecting hard output short conditions
(see
Figure 7,
page 9).
C
CP
Charge pump output terminal. A filter capacitor (up to 33 nF)
can be connected from the
C
CP
terminal and PGND. The device
can operate without the external capacitor, although the
C
CP
capacitor helps to reduce noise and allows the device to
perform at maximum speed, timing, and PWM frequency.
PERFORMANCE FEATURES
Freescale Semiconductor, Inc...
Short Circuit Protection
If an output short circuit condition is detected, the power
outputs tri-state (latch-OFF) independent of the input (IN1 and
IN2) states, and the fault status output flag is set logic Low. If
the D1 input changes from logic High to logic Low, or if the
D2
input changes from logic Low to logic High, the output bridge
will become operational again and the fault status flag will be
reset (cleared) to a logic High state.
The output stage will always switch into the mode defined by
the input terminals (IN1, IN2, D1, and D2), provided the device
junction temperature is within the specified operating
temperature.
Overtemperature Shutdown and Hysteresis
If an overtemperature condition occurs, the power outputs
are tri-state (latched-OFF) independent of the input signals and
the fault status flag is set logic Low.
To reset from this condition, D1 must change from logic High
to logic Low, or D2 must change from logic Low to logic High.
When reset, the output stage switches ON again, provided that
the junction temperature is now below the overtemperature
threshold limit minus the hysteresis.
Note
Resetting from the fault condition will clear the fault
status flag.
Active Current Limiting
The maximum current flow under normal operating
conditions is internally limited to I
LIM
(5.2 A to 7.8 A). When the
maximum current value is reached, the output stages are tri-
stated for a fixed time (t
a
) of 20
碌s
typical. Depending on the
time constant associated with the load characteristics, the
current decreases during the tri-state duration until the next
output ON cycle occurs (see
Figures 7
and
13,
page 9 and
page 12, respectively).
The current limiting threshold value is dependent upon the
device junction temperature. When -40擄C < T
J
< 160擄C, I
LIM
is
between 5.2 A and 7.8 A. When T
J
exceeds 160擄C, the I
LIM
current decreases linearly down to 2.5 A typical at 175擄C.
Above 175擄C the device overtemperature circuit detects T
LIM
and overtemperature shutdown occurs (see
Figure 5,
page 8).
This feature allows the device to remain operational for a longer
time but at a regressing output performance level at junction
temperatures above 160擄C.
Main Differences Compared to MC33186DH1
鈥?COD terminal has been removed. Terminal 8 is now a Do
Not Connect (DNC) terminal.
鈥?Terminal 20 is no longer connected in the 20 HSOP
package. It is now a DNC terminal.
鈥?R
DS(ON)
max at T
J
= 150擄C is now 225 m鈩?per each output
transistor.
鈥?Maximum temperature operation is now 160擄C, as
minimum thermal shutdown temperature has increased.
鈥?Current regulation limiting foldback is implemented above
160擄C T
J
.
鈥?Thermal resistance junction to case has been increased
from ~2.0擄C/W to ~5.0擄C/W.
33886
16
MOTOROLA ANALOG
For More Information On This Product,
INTEGRATED CIRCUIT DEVICE DATA
Go to: www.freescale.com

MC33886 PDF文件相關型號

PC33886

MC33886相關型號PDF文件下載

您可能感興趣的PDF文件資料

熱門IC型號推薦

掃碼下載APP，
一鍵連接廣大的電子世界。

在線人工客服

買家服務：
賣家服務：
技術客服：

0571-85317607

網站技術支持

13606545031

客服在線時間周一至周五
9:00-17:30

關注官方微信號，
第一時間獲取資訊。

建議反饋
返回頂部

建議反饋

聯系人：

聯系方式：

按住滑塊，拖拽到最右邊
>>
感謝您向阿庫提出的寶貴意見，您的參與是維庫提升服務的動力！意見一經采納，將有感恩紅包奉上哦！