鈥?Power-on Recall. Loads Saved Wiper Position
on Power-up.
鈥?/div>
2.5k鈩? 10k鈩?Total Pot Resistance
鈥?Endurance: 100, 000 Data Changes per Bit per
Register
鈥?100 yr. Data Retention
鈥?14 Ld TSSOP, 16 Ld SOIC
鈥?Low Power CMOS
鈥?Pb-Free Plus Anneal Available (RoHS Compliant)
BLOCK DIAGRAM
DESCRIPTION
The X9429 integrates a single digitally controlled
potentiometer (XDCP) on a monolithic CMOS
integrated circuit.
The digital controlled potentiometer is implemented
using 63 resistive elements in a series array. Between
each element are tap points connected to the wiper
terminal through switches. The position of the wiper on
the array is controlled by the user through the 2-wire
bus interface. The potentiometer has associated with it
a volatile Wiper Counter Register (WCR) and a four
non-volatile Data Registers that can be directly written
to and read by the user. The contents of the WCR
controls the position of the wiper on the resistor array
though the switches. Powerup recalls the contents of
the default data register (DR0) to the WCR.
The XDCP can be used as a three-terminal
potentiometer or as a two terminal variable resistor in
a wide variety of applications including control,
parameter adjustments, and signal processing.
V
CC
V
H
/R
H
address
data
status
2-wire
bus
interface
write
read
transfer
inc / dec
Bus
Interface &
Control
Power-on Recall
Wiper Counter
Register (WCR)
Data Registers
4 Bytes
wiper
10k鈩?/div>
64-taps
POT
control
V
SS
V
L
/R
L
V
W
/R
W
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
|
Intersil (and design) is a registered trademark of Intersil Americas Inc.
XDCP is a trademark of Intersil Americas Inc. Copyright Intersil Americas Inc. 2005. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
next