Automotive 鈥?/div>
Vehicle Security/Active Suspension/ABS
Headlight Angle Control/Tilt Sensing
Security
鈥?Gas Line/Elevator/Fatigue Sensing
Office Equipment
鈥?Computer Peripherals/PDA鈥檚/Mouse
Smart Pens/Cell Phones
Gaming
鈥?Joystick/RF Interface/Menu Selection/Tilt Sensing
Projectors -
Leveling and Keystoning
White Goods
鈥?Spin/Vibration Control
2-AXIS
SENSOR
Factory Adjust
Offset & Gain
Y axis
Low Pass
Filter
D
OUTY
V
DD
Gnd
V
DA
MXD2020E/F FUNCTIONAL BLOCK DIAGRAM
GENERAL DESCRIPTION
The MXD2020E/F is an ultra low noise and low cost, dual
axis accelerometer built on a standard, submicron CMOS
process. The MXD2020E/F measures acceleration with a
full-scale range of
鹵
1
g.
(The MEMSIC accelerometer
product line extends from
鹵1
g
to
鹵200
g
with custom
versions available above
鹵10
g.)
It can measure both
dynamic acceleration (e.g., vibration) and static
acceleration (e.g., gravity). The MXD2020E/F design is
based on heat convection and requires no solid proof mass.
This eliminates stiction and particle problems associated
with competitive devices and provides shock survival up to
50,000
g,
leading to significantly lower failure rates and
lower losses due to handling during assembly.
The MXD2020E/F provides a digital output. The outputs
are digital signals with duty cycles (ratio of pulse width to
period) that are proportional to acceleration. The duty
cycles outputs can be directly interfaced to a micro-
processor.
Information furnished by MEMSIC is believed to be accurate and reliable.
However, no responsibility is assumed by MEMSIC for its use, nor for any
infringements of patents or other rights of third parties, which may result from
its use. No license is granted by implication or otherwise under any patent or
patent rights of MEMSIC
The typical noise floor is 0.2mg /
Hz
allowing signals
below 1 milli-g to be resolved at 1 Hz bandwidth.
The
MXD2020E/F is available in a low profile LCC surface
mount package (5mm x 5mm x 2mm height). It is
hermetically sealed and operational over a -40擄C to +105擄C
temperature range.
Due to the standard CMOS structure of the MXD2020E/F,
additional circuitry can easily be incorporated into custom
versions for high volume applications. Contact the factory
for more information.
餂橫EMSIC,
Inc.
800 Turnpike St., Suite 202, North Andover, MA 01845
Tel: 978.738.0900
Fax: 978.738.0196
www.memsic.com
MEMSIC MXD2020E/FL Rev D
Page 1 of
8
11/14/2003