鉂?/div>
Fibre Channel Tape (FC-TAPE)
profile,
T11/98-124vD, rev 1.13, February 3, 1999
Supports Fibre Channel protocol SCSI (FCP-SCSI)
and Fibre Channel IP protocols
Compliance with
PCI Bus Power Management
Interface Specification
Revision 1.0 (PC98)
Supports up to 200 Mbytes/sec sustained Fibre
Channel data transfer rate
Supports SCSI initiator, initiator/target, and target
modes
Onboard, enhanced RISC processor
Onboard gigabit serial transceivers
Supports PCI dual-address cycle and cache
commands
No host intervention required to execute complete
SCSI and IP operations
Supports multi-ID aliasing in target mode
Supports external frame buffering for performance
scalability over long distances
s
s
s
ISP Initiator/Target SCSI and IP Firmware
The ISP2200A firmware implements a multitasking
host adapter that provides the host system with IP
communications and complete SCSI command and data
transport capabilities, thus freeing the host system from the
simultaneous execution of SCSI and IP traffic. The
firmware provides two interfaces to the host system: the
command interface and the Fibre Channel transport
interface. The single-threaded command interface
facilitates debugging, configuration, and recovering errors.
The multithreaded transport interface maximizes use of the
Fibre Channel and host buses.
The ISP2200A can operate simultaneously in SCSI
initiator and target modes, and supports SCSI and IP
protocols concurrently.
s
s
s
s
s
s
s
s
s
s
Software Drivers
The ISP2200A supports a host software interface
similar to the QLogic parallel SCSI and FC-AL processor
family. Existing ISP2100A software drivers for all major
operating systems are easily modified to support the
ISP2200A. The ISP2200A also supports FCP-SCSI and IP
software drivers for most major operating systems.
83220-580-01 C
ISP2200A
1
1
2
3
4
