DGP30 SERIES
SINGLE OUTPUT
DESCRIPTION
The single output DGP30 Series is designed to accept an extended
2:1 input voltage range for use in industrial and telecom
applications. The output of the converter is electrically isolated,
thereby allowing the output to be configured as a positive or
negative output voltage. For additional system utility output Trim
and Remote ON/OFF are featured. Overcurrent protection,
overtemperature protection, and output overvoltage transient
protection allow safe, reliable operation.
FEATURES
鈥?Remote ON/OFF and TRIM
鈥?Low OFF Current
鈥?Overcurrent and Overtemperature Protection
鈥?Efficiencies to 86%
鈥?Transient Output Overvoltage Protection
鈥?1544V Isolation
鈥?Five-Side Shielded Case
鈥?Extended Range Input (2:1)
BOTTOM VIEW
2.02
(51.31)
SIDE VIEW
0.040 (1.02) DIA
6 PLACES
0.700
(17.78)
0.600
(15.24)
0.400
(10.16)
0.300
(7.62)
0.000
0.100
(2.54)
0.31
(7.9)
0.11
(2.8)
0.000
5
1
2
6
1.62
(41.15)
3
7
0.3
(7.62)
1.800
(45.72)
Mechanical tolerances unless otherwise noted:
X.XX dimensions: 鹵0.020 inches
X.XXX dimensions: 鹵0.005 inches
NOTES
(1) All parameters measured at Tc = 25擄C, nominal input voltage and full rated load unless otherwise noted.
Refer to the Technical Reference Section for the definition of terms, measurement circuits and other
information.
(2) ON/OFF pin is referenced to pin 2, -Input. See DGP30 Series Application Notes for the specific
requirements of this feature.
(3) The Case is electrically connected to Pin 1, +Input.
(4) Full output trim range may not be available at minimum input voltage and full load. Full trim is
guaranteed from minimum input voltage, plus 5%, and full load.
(5) The case thermal impedance is specified as the case temperature rise over ambient per package watt
dissipated.
Rev. 04/2000
1
0.55
(13.97)
0.000
1
2
3
4
