ACT4419
Single Supply Variable Amplitude Transceivers
for MIL-STD-1553
Features
Preliminary
CIRCUIT TECHNOLOGY
www.aeroflex.com
鈥?First fully monolithic 5V only Variable Amplitude
Transceiver
鈥?Lowest standby power
鈥?Transceiver meets military data bus requirements,
MIL-STD-1553 and MIL-STD-1760
鈥?Low power dissipation at full output power
鈥?Single +5V power supply
鈥?Current source output
鈥?Monolithic construction using dielectrically isolated(D.I.)
鈥?Processed and screened to MIL-STD-883 specs
鈥?Radiation Hard to 2.5 MRADS Total Dose
鈥?DESC SMD pending
鈥?Either 5V or 10V DC control line (Factory Set)
General Description
The Aeroflex Circuit Technology
model ACT4419 is a next generation
D.I. monolithic transceiver which
provides variable amplitude in full
compliance with MIL-STD-1553/1760
data bus requirements with the lowest
standby power consumption available
and one power supply operation.
The model ACT4419 performs the
front-end analog function of inputting
and outputting data through a
transformer to a MIL-STD-1553/1760
data bus.
Design of these transceivers reflects
particular attention to active filter
performance. This results in low bit
and word error rate with superior
waveform purity and minimal zero
crossover
distortion.
Efficient
transmitter electrical and thermal
design provides low internal power
dissipation and heat rise at high as
well as low duty cycles.
Variable amplitude is adjusted with
factory preset 0 - 10 Vdc or 0 - 5 Vdc
control line at 1mA maximum input
current.
ACT4419FP & ACT4419 Plug In Transceivers
Transmitter
TX/RX
TX DATA IN
TX DATA IN
DRIVER
SHAPING
OUTPUT
STAGE
TX/RX
The Transmitter section accepts
bi-phase TTL data at the input and
when coupled to the data bus with a
TX INHIBIT
RX DATA OUT
primary grounded center tap
1:2.5 transformer
, isolated on the
data bus side with two 52.5 Ohm fault
isolation resistors, and loaded by two
70 Ohm terminations plus additional
receivers, the data bus signal
produced is 7.5Volts nominal P-P at
A-A鈥?(See Figure 5). When both DATA
and DATA inputs are held low or high,
the transmitter output becomes a
high impedance and is 鈥渞emoved鈥?/div>
from the line. In addition, an
+5 V
REFERENCE
COMP.
GROUND
INPUT
AMP
ACTIVE
FILTER
COMP.
RX DATA OUT
STROBE
Block Diagram
eroflex Circuit T
echnology
鈥?Data Bus Modules For The Future 漏 SCD4419 REV B 10/21/99
1
2
3
4
5
6
